1. Press Enter. The BIOS configuration is updated, the device reboots, and the following
output is displayed:
Gathering system information.
* Please wait this could take up to 45 seconds.
Found:
System type PP310
Bios 2.21
Memory installed 1024 MB
Slot 0: Type T1E1
FPGA 0xea * needs 0xea
Slot 1: Type Serial
FPGA 0x73
Slot 2: Type FXS
FPGA 0x5010150
ID restored No
Hit return to continue...
NOTE: For the PP332 processor, the BIOS version is 2.14 and a BIOS
upgrade is not required.
2. Reboot the device. The following output is displayed:
3. Enter n when you receive the following prompt (PP310 only):
Do you want to restore the ID from a CTPOS 4.6R7 or 5.4R3 system? [n]
The upgrade continues to completion, displaying the following information:
Upgrading T1E1 card in slot 0 to FPGA rev 0xea.
Upgrading FPGA on card 0. Please wait for completion.
. done.
Upgrading FPGA on card 0 complete.
Upgrading Winmon. Please wait for completion.
..... . done.
Upgrading Winmon complete.
Upgrading Daughter cards. Please wait for completion.
. done.
Upgrading Daughter cards complete.
**** ****
Finished preparing system for running CTPOS 6.0R1.
The system needs to be powered down.
**** ****
Hit return to power down the system.
4. Press Enter to power off the system.
21Copyright © 2015, Juniper Networks, Inc.
Chapter 2: Upgrading the CTP2000 Series Device to CTPOS 7.x
To Next Page
Loading...
