Juniper EX2300 - Rack It

NOTE: We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E
copper cable as part of the device package. If you require a console cable, you can order it
separately with the part number JNP-CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E
copper cable)
Rack It!
Here’s how to install the EX2300 switch in a two-post rack:
1. Review the General Safety Guidelines and Warnings.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end to a site ESD point.
3. Aach the mounng brackets to the sides of the EX2300 switch using the eight mounng screws
and a screwdriver.
You’ll noce there are three locaons on the side panel where you can aach the mounng brackets:
front, center, and rear. Aach the mounng brackets to the locaon that best suits where you want
the EX2300 switch to sit in the rack.
4. Li the EX2300 switch and posion it in the rack. Line up the boom hole in each mounng bracket
with a hole in each rack rail, making sure the EX2300 switch is level.
4