Juniper EX4400 - Management Cable Specifications

The calculated power margin is greater than zero, indicang that the link has sucient power for
transmission. Also, the power margin value does not exceed the maximum receiver input power.
Refer to the specicaon for your receiver to nd the maximum receiver input power.
EX4400 Management Cable Specicaons and
Pinouts
IN THIS SECTION
Management Cable Specicaons | 137
Console Port Connector Pinout Informaon | 138
USB Port Specicaons for an EX Series Switch | 139
RJ-45 Management Port Connector Pinout Informaon | 140
RJ-45 to DB-9 Serial Port Adapter Pinout Informaon | 141
Management Cable Specicaons
Table 76 on page 137 lists the specicaons for the cables that connect the console and management
ports to management devices.
Table 76:
Specicaons of Cables to Connect to Management Devices
Ports Cable Specicaons Receptacle Addional Informaon
RJ-45 Console port Rollover cable RJ-45 Connect a Device to a
Management Console
Using an RJ-45 Connector
Management Ethernet
port
Ethernet cable with an
RJ-45 connector
RJ-45 Connect a Device to a
Network for Out-of-Band
Management
137