Juniper EX4400 - Unpack an EX4400 Switch

Install the EX4400 Switch
SUMMARY
This topic guides you through the steps to install
EX4400 switches on two post racks, four-post racks,
desks, and walls.
IN THIS SECTION
Unpack an EX4400 Switch | 143
Packing List for an EX4400 Switch | 144
Register Products—Mandatory to Validate
SLAs | 145
Mount an EX4400 Switch on Two Posts of a
Rack | 146
Mount an EX4400 Switch Flush with the
Front Posts of a Four-Post Rack or
Cabinet | 149
Mount an EX4400 Switch in a Recessed
Posion in a Rack or Cabinet | 152
Mount an EX4400 Switch on a Desk or Other
Level Surface | 156
Mount an EX4400 Switch on a Wall | 157
Unpack an EX4400 Switch
We ship EX4400 switches in a cardboard carton, secured with foam packing material. The carton has an
accessory compartment.
CAUTION: EX4400 switches are maximally protected inside the shipping carton. Do
not unpack the switches unl you are ready to mount the switch.
To unpack the switch:
1. Move the shipping carton to a staging area as close to the installaon site as possible, but where you
have enough room to remove the system components.
2. Posion the carton so that the arrows are poinng up.
3. Open the top aps on the shipping carton.
4. Pull out the packing material holding the switch in place.
143