Juniper EX4400 - Page 203

conguraon, and the Link/Acvity LED on the network ports and the QSFP28 ports is lit steadily
green.
2. Commit the conguraon by using the CLI.
3. Press the factory reset/mode buon for 10 more seconds. The switch transions into inial setup
mode.
EZSetup congures DHCP and enables the J-Web user interface on the switch. You can use EZSetup
only on a standalone switch that is in the factory default conguraon. For informaon about
EZSetup, see Connecng and Conguring an EX Series Switch (J-Web Procedure).
The Factory Reset/Mode buon is enabled by default. You can disable the buon using the CLI.
To disable the Factory Reset/Mode buon, run the following commands:
1. [edit]
user@switch# set chassis config-button no-clear
2. [edit]
user@switch# commit
To enable the Factory Reset/Mode buon, run the following commands:
1. [edit]
user@switch# delete chassis config-button no-clear
2. [edit]
user@switch# commit
195