Juniper JUNOS SPACE 2.0 - VIRTUAL APPLIANCE - Changing the Password; Setting Routing Options; Adding DNS Servers

•
Setting the System Time on page 27
•
Retrieve Logs on page 27
•
Expand VM Drive Size on page 28
•
Setting Security Options on page 28
•
(Debug) Run Shell on page 29
Changing the Password
To change your password:
1. From the Junos Space Appliance Settings menu, enter 1 at the prompt.
2. Enter y when prompted to change the password for an admin user.
3. Type the new password and press Enter.
4. Retype the new password and press Enter.
Your password is updated and the setup program returns you to the main menu.
Setting Routing Options
To modify the default gateway for the management interface (eth0) or the device
management interface (eth3):
1. From the Junos Space Appliance Settings menu, enter 2 at the prompt.
2. Enter one of the following options:
•
Enter 1 to change the default gateway for the management interface (eth0).
Follow the prompts to change the IP address of the default gateway and return to
the main menu.
•
Enter 2 to change the default gateway for the device management interface (eth3).
Follow the prompts to change the IP address of the default gateway and return to
the main menu.
NOTE: Option 2 is available only when a device management interface
(eth3) was specified during the initial configuration of the virtual
appliance.
Adding DNS Servers
You can add up to three DNS servers. Enter each one using dotted decimal notation (for
example, 10.157.191.252) Each addition returns you to the main menu.
To add a DNS server:
1. From the Junos Space Appliance Settings menu, enter 3 at the prompt.
2. Enter 1 to add a nameserver.
Copyright © 2010, Juniper Networks, Inc.26
Junos Space Virtual Appliance Installation Guide