Configuring an Appliance to Add to an Existing Cluster
To configure the basic settings of a Junos Space appliance that will be added to an
existing cluster:
1. Power on the Junos Space virtual appliance:
a. From the VMware vSphere client, right-click on the Junos Space Virtual Appliance
and select Power > Power On from the drop-down menu.
b. Select the Console tab and then click inside the console display screen.
The VMware vSphere client console screen displays the Junos Space login prompt.
2. At the Junos Space login prompt, enter admin as your default login name and press
Enter.
3. Enter abc123 as your default password and press Enter.
Junos Space prompts you to change your default password.
4. Enter the default password again.
5. Enter a new password.
All passwords are case-sensitive.
6. Reenter your new password.
7. Enter a new IP address for interface eth0.
NOTE: The first and second appliance or virtual appliance that you
configure in a cluster (fabric) must be in the same subnet.
8. Enter a new subnet mask for interface eth0.
9. Enter the default gateway as a dotted decimal IP address.
10. Enter the nameserver address in dotted decimal notation for interface eth0.
11. Enter Device Management IP interface information:
If you want to configure a separate interface for device management:
•
Enter y when prompted to configure a separate interface for device management.
•
Enter a new IP address for interface eth3.
•
Enter a new subnet mask for interface eth3.
If you do not want to configure a separate interface for device management, enter n
when prompted.
12. Enter y when prompted “Will this Junos Space system be added to an existing cluster?”
The Settings Summary is displayed, as shown in the following example.
23Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring a Virtual Appliance
To Next Page
Loading...