15. Enter y to start a scan for the 40 GB of additional drive space that you added when
you deployed the virtual appliance.
16. Enter the admin password when prompted.
Junos Space start a scan for the 40 GB of additional drive space that you added when
you deployed the virtual appliance. When the scan completes, Junos Space displays
the results to verify that the file system size was increased to include the new logical
volume. The following example shows the results of a scan for additional drive space.
When the scan for additional drive space completes, the Junos Space Settings Menu
is displayed.
17. Enter Q to exit the Junos Space Settings Menu.
The basic configuration of the Junos Space Virtual Appliance is now complete.
For each appliance that you add to an existing fabric, you must add the node in the Junos
Space user interface, as described in Adding a Fabric Node.
NOTE: To log in to Junos Space from a Web browser, enter “super” as the
default user name and “juniper123” as the password.
Changing Network and System Settings for a Junos Space Virtual Appliance
You can change some of the basic configuration options that you configured when you
first installed and set up your Junos Space Virtual Appliance. You can also change system
time defaults and retrieve system log files your virtual appliance.
Each time you log in from the Junos Space system console, the Junos Space Appliance
Settings menu is displayed. Follow the system prompts from the menu to set or modify
any menu options. Password changes take effect immediately. Any configuration changes
you make do not take effect until you apply the changes.
You can perform the following tasks from the Junos Space Appliance Settings menu:
•
Changing the Password on page 26
•
Setting Routing Options on page 26
•
Adding DNS Servers on page 26
25Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring a Virtual Appliance
To Next Page
Loading...