Juniper Mesa - LED Activity Indicators; SD Cards

26 Mesa Rugged Notepad Owner’s Manual
Charging Errors
Charging errors are caused by the following:
 Baery pack(s) is too hot to charge
 Baery pack(s) is too cold to charge
 Cannot charge for unknown reason
If you have a charging error, make sure the baery pack(s) is
inserted correctly, the baery door(s) is closed properly, and
you are within the charging temperature range.
LED Activity Indicators
There are LED activity indicators located underneath the
boom row of buons that indicate the following:
 Red, solid: Waiting to boot/startup, nished charging (when
external power is applied)
 Red, blinking: External power applied, charging
 Green: Suspend and resume notication
 Blue: Not shown unless programmed
The blue and green LEDs are user programmable through
application soware.
SD Cards
The Mesa has a slot for an SD card located in baery
compartment 1 (for SD and SDHC memory cards only). To
insert or remove a card follow these steps:
1. Suspend or power o the Mesa if the only power source is
from a baery pack in baery compartment 1.
2. Loosen the screws to baery compartment 1 and remove
the door.
CAUTION: The Mesa is not totally sealed against water
and dust when baery doors are not installed and properly
latched.
3. Remove the baery pack.
!