4. Tighten the captive screws to secure the air filter unit.
5. Route the interface cables appropriately. Verify that the cables does not block the
access to router components.
Step 7: Perform Initial Software Configuration
This procedure connects the router to the network but does not enable it to forward
traffic. For complete information about configuring the router to forward traffic, including
examples, see the Junos OS configuration guides.
To configure the software:
•
Enter Configuration Mode on page 20
•
Configure User Accounts and Passwords on page 20
•
Configure System Attributes on page 21
•
Commit the Configuration on page 22
Enter Configuration Mode
1. Verify that the router is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
cli> configure
[edit]
root@#
Configure User Accounts and Passwords
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see Configuring the Root Password and authentication (Login) in the User Access
and Authentication Feature Guide for Routing Devices.
1. Add a password to the root administration user account. Enter a clear-text password.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
2. Create a management console user account.
Copyright © 2017, Juniper Networks, Inc.20
MX10003 3D Universal Edge Router Quick Start
To Next Page
Loading...
