Figure 52: Loading the MX10008 into a Rack Using a Mechanical Lift
3. Using the lift, align the router in front of the rack, centering it in front of the base brackets.
4. Lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the base brackets. Align the chassis
as close as possible to the base brackets.
5. Carefully slide the chassis onto the adjustable base and rear mounting brackets until the chassis flanges
contact the rack rails. The mounting brackets ensure that the holes in the flanges align with the holes
in the rack rails. See Figure 53 on page 146.
145
To Next Page
Loading...
