Juniper MX10008 - Removing and Installing Transceivers and Fiber-Optic Cables

•
Drape some of the cables under the handle extension and some cables over the handle extension.
Figure 157: Completed Cable Management System
g100215
Removing and Installing Transceivers and Fiber-Optic
Cables
IN THIS SECTION
Remove a Transceiver | 265
Install a Transceiver | 267
Disconnect a Fiber-Optic Cable from a Router | 269
Connect a Fiber-Optic Cable to a Router | 270
Maintain the Fiber-Optic Cables in a Router | 271
264