Figure 93: Removing the PSU Cover Panel on an MX10008
Figure 94: Removing the PSU Cover Panel on a MX10016
3. Taking care not to touch power supply connections, remove the power supply from its bag.
4. Peel back and remove the protective plastic wrap that covers all four sides of the power supply.
5. Ensure the power switch is set to the standby (O) position. This switch turns off the output voltage; it
does not interrupt AC supply.
6. Unscrew the captive screw in the counterclockwise direction by using the Phillips (+) screwdriver,
number 1.
199
To Next Page
Loading...
