NOTE: Ensure that the ejector is fully open to avoid scratching the chassis.
Figure 96: Installing a JNP10K-PWR-AC Power Supply in an MX10016
g051044
YES
Ejector fully open
NO
Ejector closed
12. Manually load balance the power supplies as you attach each power cable to a dedicated AC power
source outlet. To load balance, route the power cables to alternate between power sources. The
JNP10K-PWR-AC does not share power; all power comes into INP1 (lower receptacle) and only uses
INP2 (top receptacle) at fail over. See Figure 97 on page 202 for MX10008 and Figure 98 on page 202
201
To Next Page
Loading...
