,QVWDOOHU·V*XLGH
&KDSW HU
&RQILJXULQJWKH'HYLFH
This chapter describes how to connect a NetScreen-50 device to your network and perform
initial configuration on the device.
Topics in this chapter include:
• “Operational Modes” on page 12
– “Transparent Mode” on page 12
– “Route Mode” on page 12
• “The NetScreen-50 Interfaces” on page 13
• “Connecting the Device to a Network” on page 14
• “Establishing an HA Connection Between Devices” on page 15
• “Performing Initial Configuration Using the CLI” on page 17
– “Connecting Using a VT100 Terminal Emulator” on page 17
– “Setting an IP Address for Managing the Device” on page 17
– “Setting an IP Address for Managing the Device” on page 17
– “Allowing Outbound Traffic” on page 19
– “Changing Your Login Name and Password” on page 19
• “Accessing the Device With the WebUI” on page 19
• “Resetting the Device to Factory Default Settings” on page 20
Note: For safety warnings and instructions, please refer to the NetScreen Safety Guide.
The instructions in this guide warn you about situations that could cause bodily injury.
Before working on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents.
To Next Page
Loading...
