,QVWDOOHU·V*XLGH Y
3UHIDFH
The NetScreen-50 device provides security for small-and medium-sized companies, as
well as enterprise branch and remote offices. The NetScreen-50 device offers 170 Mbps of
firewall and 50 Mbps of 3DES VPN, protecting your LANs as well as public servers, such
as mail, web, or FTP.
*8,'(25*$1,=$7,21
This manual has four chapters and two appendices.
Chapter 1, "Overview" provides an overview of the system, its ports, and power
requirements.
Chapter 2, "Installing the Device" details how to install the NetScreen-50 device on a
desktop or in a rack.
Chapter 3, "Configuring the Device" details how to connect the NetScreen-50 device to
your network, establish a Console session, set an IP address for the NetScreen-50 device,
and access the device using the WebUI.
Chapter 4, "Replacing the Fuse" provides procedures on how to replace components on the
device.
Appendix A, "Specifications" provides a list of physical specifications about the NetScreen-
50 device.
Appendix B, "Configuration for Common Criteria, EAL2" provides information about
configuring NetScreen devices for Common Criteria, EAL2 compliance.
&200$1'/,1(,17(5)$&(&/,&219(17,216
Some of the instructions and examples provided in this manual contain CLI commands,
most of which perform initial configuration of the NetScreen-500 device. The command
examples use conventions for variables and syntax.
&/,&RPPDQG9DULDEOHV
Most NetScreen CLI commands have changeable parameters that affect the outcome of
command execution. NetScreen documention represents these parameters as variables.
Such variables may include names, identification numbers, IP addresses, subnet masks,
numbers, dates, and other values.
9DULDEOH1RWDWLRQ
The variable notation used in this manual consists of italicized parameter identifiers. For
example, the set arp command uses four identifiers, as shown here:
To Next Page
Loading...
Need help?
General
