Juniper NetScreen-50 - NetScreen-50 Attributes; Electrical Specification; Environmental; Safety Certifications

&KDSWHU&RQILJXULQJWKH'HYLFH
 ,QVWDOOHU·V*XLGH
When the device resets, the Status LED will turn amber for one-half second and
then return to the blinking green state. The serial console message states
“Configuration Erase sequence accepted, unit reset.” The system generates
SNMP and SYSLOG alerts to configured SYSLOG or SNMP trap hosts.
5. The device now reboots.
If you do not follow the complete sequence, the reset process cancels without any
configuration change and the serial console message states, “Configuration Erasure
Process aborted.” The status LED returns to blinking green. If the unit did not reset, an
SNMP alert is sent to confirm the failure.
Note: During a reset, there is no guarantee that the final SNMP alert sent to the
receiver before the reset will be received.