NetScreen-5XP 9
3
Chapter 3
Configuring the Device
This chapter describes how to configure a NetScreen-5XP device after you have installed
it on a desktop, connected it to a power source, and plugged in the necessary cables. Topics
explained in this chapter are:
• “Operational Modes” on page 10
• “The NetScreen-5XP Interfaces” on page 11
• “Establishing a Console Session” on page 12
• “Changing Your Admin Name and Password” on page 12
• “Setting an IP Address for Managing the Device” on page 13
• “Accessing the Device Using the WebUI” on page 13
• “Using the WebUI Wizards to Configure the Device” on page 14
• “Asset Recovery” on page 15
Note: You must register your product at www.juniper.net/support/ so that certain
ScreenOS services, such as the Deep Inspection Signature Service, can be activated on the
device. After registering your product, use the WebUI or CLI to obtain the subscription for
the service. For more information about registering your product and obtaining
subscriptions for specific services, see the “System Parameters” chapter in Volume 2 of the
NetScreen Concepts & Examples ScreenOS Reference Guide.
Note: If you access the device for the first time using the ScreenOS WebUI graphical
interface, the Initial Configuration Wizard appears when you log in to the WebUI. This
Wizard guides you through the configuration described in this chapter. For more
information about starting the Initial Configuration Wizard, refer to the Getting Started
Guide for the NetScreen-5XP.
To Next Page
Loading...
