Juniper PTX10008 - Page 110

•
High warning
•
Low warning
•
RX phase control loop
•
High alarm
•
Low alarm
•
High warning
•
Low warning
TIP: You can view optics-related status by using the show interfaces diagnostics optics
operational-mode CLI commands.
OT Interface Network Lane Performance Monitoring Status Messages
Network lane receive-related status:
•
Chromatic dispersion:
•
Current chromatic dispersion
•
Minimum over PM interval
•
Maximum over PM interval
•
Average over PM interval
•
Differential group delay:
•
Current differential group delay
•
Minimum over PM interval
•
Maximum over PM interval
•
Average over PM interval
•
Q
2
-factor:
•
Current Q
2
-factor
•
Minimum over PM interval
•
Maximum over PM interval
•
Average over PM interval
•
Signal-to-noise ratio (SNR)
111