Juniper PTX10008 - Figure; For the PTX10016

1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis. There is an ESD point located next to the protective earthing terminal
and below PSU 5 on the PTX10008 rear panel (see Figure 136 on page 276) or below PSU_9 on the
PTX10016 (see Figure 137 on page 276).
Figure 136: ESD Point on PTX10008 Chassis Rear
1—ESD point
Figure 137: ESD Point on PTX10016 Chassis Rear
1—ESD point
2. If the power supply slot has a cover panel on it, insert your thumb and forefinger into the finger holes,
squeeze and pull the cover out of the slot. Save the cover panel for later use. See Figure 138 on page 277
for removal on a PTX10008 and Figure 139 on page 277 for the PTX10016.
276