Figure 138: Removing the PSU Cover Panel on a PTX10008
Figure 139: Removing the PSU Cover Panel on a PTX10016
3. Taking care not to touch power supply connections, remove the power supply from its bag.
4. Peel back and remove the protective plastic wrap that covers all four sides of the power supply.
5. Ensure the power switch is set to the standby (O) position. This switch turns off the output voltage; it
does not interrupt AC supply.
6. Unscrew the captive screw in the counterclockwise direction by using the Phillips (+) screwdriver,
number 1.
7. Rotate the captive screw away from the faceplate of the power supply to release the latch.
277
To Next Page
Loading...
