Table 68: Physical Specifications of a JNP10K-PWR-DC2 Power Supply
ValueSpecification
3.5 in. (8.89 cm)Height
3.6 in. (1.63 cm)Width
16.05 in. (40.77 cm)Depth
8.1 lb (3.67 kg)Weight
PTX10000 Grounding Cable and Lug Specifications
NOTE: A ground connection to the protective earthing terminal is not required for an AC powered
switch. The AC power cords provide adequate grounding when you connect the power supply in
the switch to a grounded AC power outlet by using the AC power cord appropriate for your
geographical location.
For installations that require a separate grounding conductor to the chassis, the router must be adequately
grounded before power is connected to ensure proper operation and to meet safety and electromagnetic
interference (EMI) requirements. To ground a PTX10000 chassis, connect a grounding cable to earth
ground and then attach it to the chassis grounding point on the rear of the chassis beneath.
WARNING: The router is pluggable type A equipment installed in a restricted-access
location. It has a separate protective earthing terminal provided on the chassis in addition
to the grounding pin of the power supply cord. This separate protective earthing terminal
must be permanently connected to earth ground for installations that require a separate
grounding conductor to the chassis.
WARNING: To comply with GR-1089 requirements, all intrabuilding copper cabling used
for SFP+, QSFP+, and QSFP28 ports must be shielded and grounded at both ends.
182
To Next Page
Loading...
