Table 71: Console Port Connector Pinouts for the PTX10000 Series
DescriptionSignalPin
Request to sendRTS Output1
Data terminal ready
Time of day for Precision Time Protocol
(PTP). You can use DTR pins as a TOD
universal asynchronous
receiver/transmitter (UART) by using
breakout cables.
DTR Output
TOD Output for PTP applications
2
Transmit dataTxD Output3
Signal groundSignal Ground4
Signal groundSignal Ground5
Receive dataRxD Input6
Data carrier detect
Time of day for PTP. You can use DCD
pins as a TOD UART by using breakout
cables.
DCD Input
TOD Output for PTP applications
7
Clear to sendCTS Input8
SEE ALSO
Connecting a PTX10000 Router to a Management Console | 237
USB Port Specifications for the PTX10000 Series
The following Juniper Networks USB flash drives have been tested and are officially supported for the
USB port in the PTX10000 Series:
•
RE-USB-1G-S—1-gigabyte (GB) USB flash drive
•
RE-USB-2G-S—2-GB USB flash drive
191
To Next Page
Loading...
