Figure 87: Attaching Front Panel Brackets on a PTX10016
6. Use the final two mounting screws to attach a latch bracket to the top right of the chassis frame so
there are brackets on all four corners of the front of the chassis.
7. Lift the front panel and rest it on the two bottom brackets.
8. Slide the panel back on the bracket glides until it engages on the two ramps.
9. Tilt the panel towards the chassis until it is vertical with the chassis. The blue release buttons on the
side of the panel click into place (see Figure 88 on page 221 for PTX10008 and Figure 89 on page 222
for PTX10016).
220
To Next Page
Loading...
