Table 79: Setting the JNP10K-PWR-AC2 Dip Switches
FieldStateSwitch
IP0 is presentOn1
IP0 is not presentOff
IP1 is presentOn2
IP1 is not presentOff
Enabled for 30 A feed; 5500-W for a single feed, 5000-W for dual feedsOn3
Enabled for 20 A feed; power supply capacity is 3000-WOff
15. Verify that the INP1 and INP2 LEDs on the power supply faceplate are lit and are on steadily.
16. Press the power switch to the on (|) position.
How to Remove a JNP10K-PWR-DC Power Supply
The JNP10K-PWR-DC power supply in a PTX10008 and in a PTX10016 chassis is a hot-removable and
hot-insertable field-replaceable unit (FRU). You remove DC power supplies from the rear of the chassis.
CAUTION: Before you remove a power supply, ensure that you have power supplies
sufficient to power the router left in the chassis. See “Power Requirements for PTX10000
Components” on page 165.
WARNING: Before performing DC power procedures, ensure that power is removed
from the DC circuit. To ensure that all power is off, locate the circuit breaker on the panel
board that services the DC circuit, switch the circuit breaker to the off (O) position, and
tape the switch handle of the circuit breaker in the off position.
Before you remove a DC power supply from the router:
292
To Next Page
Loading...
