CAUTION: Before you remove a power supply, ensure that you have power supplies
sufficient to power the router left in the chassis. See PTX10008 Power Planning and
“Power Requirements for PTX10000 Components” on page 165.
Before you remove a DC power supply from the router:
•
Ensure you understand how to prevent ESD damage. See “Prevention of Electrostatic Discharge Damage”
on page 427.
Ensure that you have the following parts and tools available to remove a JNP10K-PWR-DC2 power supply:
•
Heat protective gloves able to withstand temperatures of 158°F (70°C)
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, numbers 1 and 2
•
13/32 in. (10 mm) nut driver or socket wrench
•
Replacement power supply or a cover for the power supply slot
CAUTION: Do not leave the power supply slot empty for a long time while the router is
operational. Either replace the power supply promptly or install a cover over the empty
slot.
To remove a JNP10K-PWR-DC2 power supply from a PTX10000 router:
308
To Next Page
Loading...
