Figure 199: Removing the SIB from a PTX10016 Chassis
8. Support the SIB as you rotate the SIB 90 degrees and place it on the antistatic mat with the printed
circuit (PC) board facing upward. Be careful not to bump or handle the SIB by the connectors. If you
do not have an antistatic mat, have another person help you slide the electrostatic bag over the SIB
before placing it on the stable surface. See Figure 200 on page 337.
CAUTION: Do not stack hardware components on top of one another after you
remove them. Place each component on an antistatic mat resting on a stable, flat
surface.
336
To Next Page
Loading...
