25
4 Permanent settings in programming mode
4 Permanent settings in programming mode
Touch ‘P’ to enter programming mode. Move your finger across the
display to navigate through the programme items and permanently
save the desired settings. The following settings can be made:
Programme item Sub-item Explanation
‘Machine settings’ ‘Switch off after’
T Set the time after which the Z8 should switch
off automatically.
‘Save energy’
T Activate energy-saving mode.
‘Factory setting’
T Reset the machine to its factory setting.
‘Units’
T Select the unit for the amount of water.
‘Display’
T Change the display settings.
‘Water hardness’
T Adjust the water hardness.
‘Choose language’
T Select your language.
‘Water tank illumination’
T Change the setting for water tank illumina-
tion.
‘Product counter’,
‘Maintenance counter’
T Keep track of all products prepared and view
the number of maintenance programmes
performed.
‘Connect accessory’,
‘Disconnect accessories’
T Connect the Z8 wirelessly to a JURA accessory
or disconnect the connection again.
‘Empty system’
T Empty the system to protect it from frost
during transport.
‘Version’ Software version
‘Maintenance
status’
‘Clean the milk system’,
‘Clean’,
‘Change the filter’ (only if
filter is fitted),
‘Descale’,
‘Rinse’,
‘Maintenance information’,
‘Lock display’
T Start the required maintenance programme
here.
‘Product settings’
T Select your settings for speciality coffees and
hot water.
To Next Page
Loading...
