Jura Z8 - Page 27

27
4 Permanent settings in programming mode
Product Coffee
strength
Amount More settings
Latte macchiato 10 levels Coffee: 25ml–240ml
Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Interval: 0sec.–60sec.
Milk and milk foam tempera-
ture, temperature (low, normal,
high), product name, delete/
replace/copy product
Espresso macchiato 10 levels Coffee: 15ml–80ml
Milk foam:
0sec.–120sec.
Milk foam temperature,
temperature (low, normal,
high), product name, delete/
replace/copy product
Flat white,
caffè latte
10 levels Coffee: 25ml–240ml
Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Milk and milk foam tempera-
ture, temperature (low, normal,
high), product name, delete/
replace/copy product
Pot of coffee 10 levels Coffee: 25ml–240ml
Bypass water:
0ml–240ml
Temperature (low, normal,
high), product name, delete/
replace/copy product,
number of strokes (1–5; set
number is displayed during
preparation)
Portion of milk foam,
Portion of milk
– Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Milk and milk foam tempera-
ture, product name, delete/
replace/copy product
Hot water,
hot water for green tea,
hot water for black tea
– Water: 25ml–450ml Temperature (low, normal,
high), product name, delete/
replace/copy product
Permanent settings in programming mode always follow the same
model.
Example:Proceed as follows to change the coffee strength for one
espresso.
Precondition:The start screen is displayed.
T Touch
‘Espresso’ for about 2 seconds until the list of possible
settings is displayed.
T Touch
‘Product settings’.
‘Espresso’
T Move your finger across the display until ‘Coffee strength’ is
displayed in the centre.