EN 51
15° 15°
15° 15°
4
Position the transmitting and receiving
equipment so that their infrared transmitter
and receiver face opposite each other.
•The distance between them should be less
than 50 cm, and the transmitter and receiver
should be angled no more than 15° to each
other.
5
If the camera is the transmitting equipment,
press the FLASH/TRANSFER Button.
•The message “TRANSMISSION IN
PROGRESS” is displayed, and image transfer
starts.
•During image transfer, only one image should
be displayed. If a menu screen or index
screen is displayed, transfer is impossible.
•If the message “TRANSMISSION FAILED” is
displayed 30 seconds after the FLASH/
TRANSFER Button is pressed, check the
equipment orientation, power supplies, etc.
and retry the transfer.
•To abort transfer in the middle, press the
CLEAR/FOCUS Button. The message
“TRANSMISSION TO BE STOPPED” is
displayed.
6
If the camera is the receiving equipment, the
message “RECEPTION IN PROGRESS” is
displayed.
•Reception is complete when this message
disappears.
•If the message “RECEPTION FAILED”
appears, check the equipment orientation,
power supplies, etc. and retry the transfer.
•To abort transfer in the middle, press the
CLEAR/FOCUS Button.
•Image data is received in the “FINE” Picture
Quality mode.
•It is recommended that you use the optional
AC power adapter during data transfer.
< 50 cm
IrTran-P infrared
communication
compatible equipment
To Next Page
Loading...
Need help?
General
