To Next Page

To Previous Page

Viewing HDR10+ Content

Press the [MENU] button to display the menu, and set “Content Type” to “Auto” or

“HDR10+” in the “Picture Adjust” menu.

Enter the HDR10+ content.

When

“Input

Signal” " “HDMI EDID Setting” " “HDR10+” is configured to “Off”, the receiving of HDR10+ is disabled.

To enjoy HDR10+ content, configure to “On”. (“HDMI EDID Setting”P. 76)

Setting Frame Adapt HDR

Press the [MENU] button to display the menu, and set “Content Type” to “Auto” or

“HDR10” in the “Picture Adjust” menu.

Configure “Picture Mode” to “Frame Adapt HDR” in the “Picture Adjust” menu.

You can also press the [PICTURE MODE] button and use the ↑↓ keys “Frame Adapt HDR” to select and

configure a setting. (P.

39)

Enter the HDR10 content when “Picture Mode” is configured to “Auto”.

Configure to “HDR Processing” in the “Picture Adjust” menu.

(“HDR Processing”P. 70)

Configure to “HDR Level” in the “Picture Adjust” menu.

(“HDR Level”P. 71)

* This can be configured only when “Picture Mode” is configured to “Frame Adapt HDR”.

MEMO

If you wish to watch HDR10 content in the “Frame Adapt HDR” picture mode, we recommend that you enable

automatic switching to “Frame Adapt HDR” in “Input Signal”"“Auto Pic.Mode Select”"“HDR10”. (“Auto Pic.Mode

Select”P.

75)

Configuring “Theater

Optimizer” to “On” enables “HDR Level” to be configured automatically according to the screen

size and state of the projector. (“Theater Optimizer”P. 71)

Adjust/Set

Questions and Answers:

Need help?

Do you have a question about the JVC DLA-NP5 and is the answer not in the manual?

JVC DLA-NP5 Specifications

General