To Next Page

To Previous Page

HDMI EDID Setting

Mode

For changing the EDID mode of the “HDMI 1/HDMI 2” terminal. Set to “A” under normal condition. The images may not

be displayed on some old devices. In this case, try “B” or “C”.

Setting Description

Configures the EDID mode to “A”

Supports up to 8K60p x y z 5 6 7 and 4K120p.

Configures the EDID mode to “B”

Supports up to 4K60p.

Configures the EDID mode to “C”

Supports up to 1080p60.

* EDID (Extended Display Identification Data) refers to the information, such as supported resolutions, exchanged

between devices.

DSC

For configuring whether DSC transmission is allowed. Set to “On” under normal condition.

Setting Description

On Allows compressed video transmission

Off Prohibits compressed video transmission

* DSC (Display Stream Compression) is one of the lossy video signal compression transmission technologies.

HDR10+

For configuring whether HDR10+ transmission is allowed. To enjoy HDR10+ content, configure to “On”.

Setting Description

On Allows HDR10+ transmission

Off Prohibits HDR10+ transmission

MEMO

The “HDMI

EDID Setting” settings are saved separately for each input terminal. The name of the currently selected

input terminal is shown at the top right corner of the “HDMI EDID Setting” menu.

To switch

to configure the settings for a different input terminal, press the “INPUT” button on the remote control unit,

or press the ↑↓ key on the projector unit after turning off the menu screen.

Adjust/Set

Questions and Answers:

Need help?

Do you have a question about the JVC DLA-NP5 and is the answer not in the manual?

JVC DLA-NP5 Specifications

General