Adjusting Focus Manually
Set this when the focus is not clear in Intelligent Auto or when manual
focusing is desired.
Memo :
To select/move cursor towards up/left or down/right, press the button UP/<
or DOWN/>.
.
1
Select the Manual recording mode.
.
0
If the mode is P Intelligent Auto, press the i.AUTO 2 times to switch.
The mode changes between Intelligent Auto and Manual with every
press.
2
Press MENU.
.
3
Select “MANUAL SETTING” and press OK.
.
4
Select “FOCUS” and press OK.
.
5
Select “MANUAL” and press OK.
.
6
Adjust the focus with the UP/< and DOWN/> buttons.
.
0
Press UP/< to focus on a distant subject.
If E appears blinking, focus cannot be set any further.
0
Press DOWN/> to focus on a near subject.
If p appears blinking, focus cannot be set any nearer.
7
Press OK to confirm.
.
0
When focus is confirmed, the focusing frame disappears and E and
p are displayed.
Memo :
0
A subject that is focused at the telephoto (T) end remains in focus when
it is zoomed out to the wide angle (W) end.
0
“FOCUS” cannot be set during “TIME-LAPSE RECORDING”.
Recording
25
To Next Page
Loading...
