Setting the Enforced Group Owner (DIRECT MONITORING)
Sets whether to enforce authorization of the group owner.
1
Tap “MENU”.
(Operation on this camera)
.
0
The shortcut menu appears.
2
Tap “Wi-Fi” (
Q
) in the shortcut menu.
(Operation on this camera)
.
3
Tap “NETWORK SETTINGS”.
(Operation on this camera)
.
4
Tap “Wi-Fi DIRECT SETTING”.
(Operation on this camera)
.
NETWORK SETTINGS
Wi-Fi DIRECT SETTING
5
Tap “ENFORCED GROUP OWNER”.
(Operation on this camera)
.
Wi-Fi DIRECT SETTING
SET
ENFORCED GROUP OWNER
0
Tap “ON” or “OFF”.
0
It is recommended to select “ON” usually.
If connection to devices that support Wi-Fi Direct fails, set to “OFF”.
0
After setting, tap “SET”.
Memo :
0
When set to “OFF”, connection to devices that do not support Wi-Fi Direct
will be disabled.
Checking the MAC Address of this Camera
Displays the MAC address of the camera.
1
Tap “MENU”.
(Operation on this camera)
.
0
The shortcut menu appears.
2
Tap “Wi-Fi” (
Q
) in the shortcut menu.
(Operation on this camera)
.
3
Tap “NETWORK SETTINGS”.
(Operation on this camera)
.
4
Tap “MAC ADDRESS”.
(Operation on this camera)
.
NETWORK SETTINGS
MAC ADDRESS
0
The MAC address of the camera appears.
(The above shows the MAC address when connected to an access
point, while the below shows the address during direct connection.)
0
After setting, tap “SET”.
Using Wi-Fi
41
To Next Page
Loading...
