70
11. MENU SCREENS
MASTER
BLACK
DETAIL
DTL. V/H
BALANCE
SKIN DTL
DETECT
SCAN
WHITE CLIP
KNEE
POINT
ADVANCED
PROCESS
PAGE BACK
NORMAL
NORMAL
NORMAL
OFF
VIDEO
108%
100%
–––––
11-6CAMERA PROCESS MENU Screen
Item Function Variation Range Initial Setting
Adjusts the pedestal level (master black), which is the reference of black.
● To increase the pedestal level .... Increase the number. (UP)
● To decrease the pedestal level ... Decrease the number. (DOWN)
Adjusts the detail enhancement level.
● To sharpen details....................... Increase the number. (UP)
● To soften details .......................... Decrease the number. (DOWN)
Sets the direction, horizontal (H) or vertical (V), in which stronger detail
enhancement is applied.
To strengthen the H enhancement......Increase the number (UP).
To strengthen the V enhancement ......Decrease the number (DOWN).
Sets the Skin Detail function to ON or OFF.
ON :Skin Detail function activated.
OFF :Skin Detail function not activated.
☞ See “Using the Skin Detail Function” on page 86.
Increases the vertical resolution.
● VIDEO :Vertical resolution 380 lines.
● FRAME MODE :Vertical resolution 450 lines
Sets the point where white clipping is to take place for an input video
signal with a high luminance level.
108% :The luminance level is white-clipped at the point of 108%.
100% :The luminance level is white-clipped at the point of 100%. If the
screen appears too white even with the point set at 108%, set the
point at 100%.
Sets the knee point (brightness level) when the AUTO KNEE function is
set to OFF.
Displays the ADVANCED PROCESS Screen.
☞ See “ADVANCED PROCESS Screen” on page 71.
The TOP MENU returns when the SHUTTER dial is pressed with the
cursor at this position.
MAX (10)
9
to
NORMAL (0)
to
–9
MIN (–10)
MAX (10)
9
to
NORMAL (0)
to
–9
MIN (–10)
H-MAX (5)
4
to
NORMAL (0)
to
–4
H-MIN (–5)
ON
OFF
VIDEO
FRAME MODE
108%
100%
100%
96%
92%
88%
84%
80%
–––––
The CAMERA PROCESS menu screen is only displayed in the Camera mode.
Note:
In the FRAME MODE the bright sections may be coloured depending
on the colour temperature of the subject.
Note:
When LOLUX is ON, “FIX” is displayed and setting is not possible.
Note:
When LOLUX is ON, “FIX” is displayed and setting is not possible.
To Next Page
Loading...
Need help?
General
