JVC GY-HM600U - Audio Set Item

Audio Set Item
Input1 Mic Ref.
For setting the reference input level when the
[INPUT1] selection switch is set to “MIC” or “MIC
+48V”.
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB]
Input2 Mic Ref.
For setting the reference input level when the
[INPUT2] selection switch is set to “MIC” or “MIC
+48V”.
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB]
Int. Mic Gain
For setting the sensitivity of the built-in microphone.
[Setting Values: +12dB, +6dB, R0dB]
AUX Gain
For setting the sensitivity of the [AUX] terminal
input.
[Setting Values: +12dB, +6dB, R0dB]
Ref. Level
For setting the audio reference level to be recorded
to the SD card. (Applies to both [CH1/CH2].)
[Setting Values: -12dB, -18dB, R-20dB]
Limiter
For setting the limiter operation.
0
Ref. Level:
Sets “Ref. Level” to the maximum recording
level.
0
-8dBFS, -5dBFS:
Sets “-8dBFS” or “-5dBFS” to the maximum
recording level.
0
Off:
Depending on the settings of the [CH1/CH2
AUTO/MANUAL] selection switches, the
operation may be different as described below.
0
The limiter does not function when
“MANUAL” is set.
0
The limiter functions at -5 dBFS when
“AUTO” is set.
[Setting Values: Ref. Level, -8dBFS, R-5dBFS, Off]
AGC Response
9
Attack Time
Sets the time to activate the limiter.
[Setting Values: Fast, RMiddle, Slow]
9
Decay Time
Sets the time to deactivate the limiter operation.
[Setting Values: Fast, RMiddle, Slow]
AGC Mode
For setting whether to link the limiter operation of
[CH1] and [CH2].
Select “Link” to link or “Separate” to separate.
[Setting Values: Link, RSeparate]
Memo :
0
Enabled only when both the [AUX] input terminal
and [INPUT1/INPUT2] input terminal are set to
“LINE” or “MIC”, and CH1/CH2 of the [CH1/CH2
AUTO/MANUAL] switch is set to “AUTO”.
XLR Manual Level
For setting whether to link manual audio
adjustment operation between [INPUT1] and
[INPUT2] terminals.
Select “Link” to link or “Separate” to separate.
[Setting Values: Link, RSeparate]
Memo :
0
Enabled only when both the [INPUT1/INPUT2]
input terminals are set to “LINE” or “MIC”, and
both [CH1]/[CH2] of the [CH1/CH2 AUTO/
MANUAL] selection switches are set to
“MANUAL”.
Int. Mic Separation
For setting the enhancement level of the stereo
effect of the built-in microphone.
0
1 to 4:
Enhances the stereo effect. Increasing the value
increases the stereo effect.
0
Effect off:
Does not enhance the stereo effect.
0
Mono:
Sets the built-in microphone to monaural.
[Setting Values: 1 to 4, Effect off, Mono (R2)]
Memo :
0
When any value from 1 to 4 is selected, the
sound quality changes slightly due to the
process of enhancing the stereo effect. This is
normal.
0
This menu is enabled when the [CH1]/[CH2]
selection switch is set to “INT”.
102
Menu Display and Detailed Settings