JVC GY-HM600U - Adjusting Audio Recording Level

Adjusting Audio Recording Level
You can select to adjust the audio recording levels
for the two channels (CH1/CH2) manually or
automatically.
.
FULL AUTO
ON
OFF
CH1
INT
INPUT1
INPUT2
AUTO
MANUAL
CH2
L
C
CH2CH1
Manual Adjustment Mode (Manual
Adjustment)
0
Set the [CH1/CH2 AUTO/MANUAL] switch on
the camera recorder to “MANUAL” to enter the
manual adjustment mode, and use the [CH1]/
[CH2] recording level adjustment knob to set the
recording level.
0
You can adjust the level manually during the
recording, recording standby, and stop modes.
o Setting Input Channel to “INPUT1”/“INPUT2”
1
Set the [CH1/CH2 AUTO/MANUAL] selection
switch to “MANUAL” for the channel to be
adjusted manually.
2
Turn the corresponding [CH1]/[CH2] recording
level adjustment knob to adjust the level.
When [Limiter] in the [Audio Set] menu is set to
“Off”, adjust such that the audio level meter
does not light up at -2 dB even for loud sounds.
(A P102 [ Limiter ] )
.
P13000K
1/100
F1. 6
0
dB
AE+6
ND 1 /64
12 :34 :56
Jan 24 , 2012
00: 00:00.00
40
30 20
10
0
5 . 6 f t
4030 20
10
0
-2dB
o Setting Input Channel to “INT” for Both [CH1] and
[CH2]
1
Set the [CH1 AUTO/MANUAL] selection switch
to “MANUAL”.
2
Turn the [CH1] recording level adjustment knob
to adjust the level.
When the built-in microphone and the [AUX]
input terminal are used, the recording levels of
[CH1] and [CH2] are interlocked.
This is also effective when the [CH1 AUTO/
MANUAL] selection switch is set to [CH2].
Memo :
0
Select [Limiter], [AGC Response], [AGC Mode],
or [Int. Mic Separation] in the menu to set the
recording audio.
0
Set [Ref. Level] in the [Main Menu] B [A/V
Set] B Audio Set menu to “-20dB”, “-18dB”, or
“-12dB” for the reference level to be recorded on
SD cards. (common for CH1/CH2)
(A P102 [ Ref. Level ] )
0
The operations of the [CH2] recording level
adjustment knob and [CH2 AUTO/MANUAL]
selection switch are disabled.
Automatic Adjustment Mode
0
Set the [CH1/CH2 AUTO/MANUAL] selection
switch to “AUTO” or the [FULL AUTO] switch to
“ON” to enter Automatic Adjustment mode. The
audio recording level is set automatically
according to the input level.
0
When the [FULL AUTO] switch is set to “ON”,
mode switching with the [CH1/CH2 AUTO/
MANUAL] selection switch is disabled.
Memo :
0
When [Limiter] in the [Main Menu] B [A/V Set] B
[Audio Set] menu is set to “Off” while in the
automatic adjustment mode, the limiter
operates at -5dBFS.
If [Limiter] is set to other than “Off”, the limiter
operates according to the value set.
(A P102 [ Limiter ] )
0
When [Audio On FULL AUTO] in the [A/V
Set] B [Audio Set] menu is set to “SW Set”, you
can switch the audio recording mode with the
[CH1/CH2 AUTO/MANUAL] selection switch on
the camera recorder even if the [FULL AUTO]
switch is set to “ON”.
(A P103 [ Audio On FULL AUTO ] )
58
Shooting