JVC GY-HM600U - Synchronizing Time Code on Another Camera

Synchronizing Time Code
on Another Camera
This camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1
Connect the [TC] terminal of the master device
with the [TC] terminal of the slave device.
Set the [TC IN/OUT] switch of the master device
to “OUT”, and the [TC IN/OUT] switch of the
slave device to “IN”.
.
AUX
INPUT2
INPUT1
D
E
V
IC
E
A
V
A
BATT.RELEASE
POWER
/CHG
B
H
D
M
I
R
E
M
O
T
E
D
C
H
D
/S
D
S
D
I
REC
AUX
INPUT2
INPUT1
D
E
V
IC
E
A
V
A
BATT.RE L E
ASE
POWER
/CHG
B
H
D
M
I
R
E
M
O
T
E
D
C
H
D
/S
D
S
D
I
REC
IN
OUT
TC
IN
OUT
TC
[IN]
Slave Device
(This Camera Recorder)
[OUT]
Master Device
Settings and Operation of the Camera
Recorder
1
Set to Camera mode.
(A P16 [Operation Modes] )
2
Set [TC/UB] B [TC Generator] as follows.
0
Slave device:
Select “Free Run(Ext)”.
0
Master device:
Select “Free Run”.
3
Set LCD monitor or viewfinder to Display 1
screen.
4
Set the master device and run the time code.
0
When the built-in time code generator is
synchronized with the external time code
data input, the Z icon on Display 1 screen
lights up.
0
When time code is not synchronized or time
code input is not available, the Z icon goes
out.
.
P13000K
1/100
F1. 6
0
dB
AE+6
ND 1 /6 4
12 :34 :56
Jan 24,2012
00:00: 00.00
40
30 20
10
0
5 . 6 f t
Memo :
0
The built-in time code generator will continue
operation even when the master device is
disconnected after synchronization.
0
User’s bit will become data in the master device.
0
While the [TC] terminal is connected, the time
code may be out of synchronization when the
[A/V Set] B [Video Set] B [HDMI/SDI Out]
setting of the Master device and Slave device is
being changed.
(A P101 [ HDMI/SDI Out ] )
64
Shooting