JVC GY-HM600U - Monitoring Audio Sound During Recording Using a Headphone

Monitoring Audio Sound
During Recording Using a
Headphone
You can check the recorded audio using
headphone.
.
AUX
MONITOR
CH1
BOTH
CH2
3
1
2
1
Connect the headphone.
2
Select the channel to monitor with the
[MONITOR] selection switch.
Setting Description
[CH1] Outputs the audio recorded in [CH1].
[BOTH] Outputs the audio recorded in
[CH1/CH2].
[CH2] Outputs the audio recorded in [CH2].
3
Use the [MONITOR +/-] button to adjust the
monitor volume.
Memo :
0
Audio during recording is not output from the
monitor speaker.
0
Warning tone is output when there is an
abnormality in the camera recorder or when the
battery is low.
(A P130 [Warning Tone] )
Selecting Audio Output Method When the
[MONITOR] Selection Switch Is Set to
“BOTH”
When a stereo type earphone jack is connected,
perform the following setting to output stereo
sound.
1
Set the [MONITOR] selection switch to “BOTH”.
2
Set [Main Menu] B [A/V Set] B [Audio Set] B
[Monitor] to “Stereo”.
(A P103 [ Monitor ] )
Memo :
0
You can set the volume of the warning tone in
[Main Menu] B [A/V Set] B [Audio Set] B [Alarm
Level]. (“Off”/“Low”/“Middle”/“High”)
(A P103 [ Alarm Level ] )
59
Shooting