JVC GY-HM600U - Page 54

Preset Mode (PRESET)
0
Two different color temperature settings are
registered on this camera recorder. You can
switch between them using the [y] button.
(Default setting: “3200K” 1 “5600K”)
0
Press the [y] button to switch to a different
color temperature.
(“Preset Temp.” 1 “Alternative Temp.”)
1
Set the [WHT BAL B/A/PRESET] switch to
“PRESET”.
2
Press the [y] button.
Setting the [Preset Temp.] or [Alternative
Temp.] Values
You can change both the color temperature
settings in the Preset mode in the menu.
1
Open the [Preset Temp.] or [Alternative
Temp.] menu.
0
Select [Main Menu] B [Camera Process] B
[White Balance] menu B [Preset Temp.]
and [Alternative Temp.], and press the Set
button ( R ).
0
The Color Temperature setting screen
appears.
.
Color Temperature
Detailed Selection
Screen
Color Temperature Selection Screen
2
Select the color temperature.
0
When selecting from a setting value (Color
Temperature Selection screen), use the
cross-shaped button (JK) to select the color
temperature.
[Setting Values: 7500K, 6500K, 5600K,
5200K, 4800K, 4200K, R3200K, 3000K,
2800K]
0
To select detailed values (Color
Temperature Detailed Selection screen)
0
Press the cross-shaped button (I) to
display the Color Temperature Detailed
Selection screen.
0
Use the cross-shaped button (JK) to
select a color temperature.
[Setting Values: 2300K to 15000K (in
100K increments)]
Memo :
0
Use the cross-shaped button (I) to switch
between the Color Temperature Selection
screen and the Color Temperature Detailed
Selection screen.
Memory A Mode (A), Memory B Mode
(B)
0
Set to the white balance saved in Memory A or
Memory B.
0
When the [WHT BAL B/A/PRESET] selection
switch is set to “A” or “B”, press the [y] button
to execute white balance. The white balance will
be automatically adjusted and the adjusted
value will be saved in Memory A or Memory B.
1
Prepare the camera recorder.
A
Set the [POWER ON/OFF(CHG)] switch to “ON”.
B
Press the [IRIS] button to set to the Auto mode.
C
Set the [FULL AUTO] switch to “OFF”.
2
Set the [ND FILTER] switch according to the
lighting.
(A P53 [Setting the ND Filter] )
3
Set the [WHT BAL B/A/PRESET] selection
switch to “A” or “B”.
4
Locate a place with similar lighting conditions
as the object to be shot, place a white object
near the center of the screen and zoom in to fill
the screen with white.
5
Press the [y] (Auto White Balance) button.
0
The white detection frame appears when
Auto White Balance is activated. Fill the
frame with white completely.
0
“AUTO WHITE A OPERATION” or “AUTO
WHITE B OPERATION” appears on the
viewfinder when Auto White Balance is
activated.
0
When the correct white balance is achieved,
“AUTO WHITE A OK” or “AUTO WHITE B
OK” appears for about 3 seconds together
with the approximate color temperature.
54
Shooting