Display Settings Item
This menu is used to set the displays on the LCD
monitor and viewfinder screen.
Zoom
For setting the display method of the zoom
position.
0
Number:
Displays the zoom position in numbers (0-99).
0
Bar:
Displays the zoom position in a bar.
0
Off:
Does not display the zoom position.
[Setting Values: Number, RBar, Off]
Focus
For setting the display method of the focal length
during manual focus.
0
Feet:
Displays the focus in feet.
0
Meter:
Displays the focus in meters.
0
Off:
Does not display the focal length during focus.
[Setting Values: Feet, RMeter, Off]
ND Filter
For setting whether to display the filter position.
0
On+Assist:
Displays the current filter position.
If the ND filter setting is inappropriate, the
appropriate ND filter to select will appear
blinking.
0
On:
Displays the current filter position.
0
Off:
Hides the filter position.
[Setting Values: On+Assist, ROn, Off]
Record Format
For setting whether to display the video format
during recording or playback.
[Setting Values: ROn, Off]
Media Remain
For
setting whether to display the remaining space
of the recording SD card.
[Setting Values: ROn, Off]
Memo :
0
When the remaining space warning is
displayed, the information appears even when
“Off
” is selected.
0
The displayed time is an estimate.
TC/UB
For specifying whether to display the time code
(TC)
or user’s bit (UB) rate in the display on the LCD
monitor and viewfinder screen.
[Setting Values: UB, RTC, Off]
Audio Meter
For specifying whether to display the audio level
meter on the LCD monitor and viewfinder screen.
[Setting Values: ROn, Off]
Battery
For setting the display of the remaining battery
power in the display on the LCD monitor and
viewfinder screen.
The battery information appears only on the
Display 1 screen in Camera mode.
(A P119
[Display 1 screen] )
0
Time:
Displays the remaining battery power in
minutes. (min)
0
Capacity%:
Displays the remaining battery power in
percentage. (%)
0
Voltage:
Displays the current battery voltage in units of
0.1 V. (V)
0
[Off
]:
The remaining battery power is not displayed.
[Setting Values: RTime, Capacity%, Voltage, Off]
Memo :
0
The battery mark that appears before the “Time”,
“Capacity%” or “Voltage” value changes
according to the remaining battery power.
4
: 10 % and below
D
: 11 % to 30 %
C
: 31% to 70 %
B
: 71 % to 100 %
0
When the remaining battery power is low, “RES”
instead of the value is displayed.
Replace the battery as soon as possible.
0
The remaining battery power and remaining
time are intended as reference values for the
shooting duration.
106
Menu Display and Detailed Settings
To Next Page
Loading...
Need help?
General
