Symptom Action
The time code and user’s bit
are not displayed.
0
Even in Camera mode or Media mode, the time code and user’s bit
may not be displayed depending to the type of display.
0
Is [LCD/VF] B [Display Settings
] B [TC/UB] set to “Off”? To display
the time code or user’s bit, set it to “TC” or “UB”.
(A P
106 [ TC/UB ] )
The date and time are not
displayed.
0
The date and time are only displayed on the Display 1 and Display 2
screens in the Camera mode (during shooting).
(A P119
[Display Screen in Camera Mode] )
0
Is [System] B [Record Set] B [Time Stamp] set to “On”? To display
the date and time, set it to “Off”.
(A P114
[ Time Stamp ] )
Incorrect display on the
viewfinder.
Is the LCD monitor used with [LCD/VF]
B
[LCD + VF] set to “Off”?
(A P103 [ LCD + VF ] )
The actual recording time is
shorter than the estimated
time.
0
The recordable time may be shorter depending on the shooting
conditions or the subject.
The two camera recorders are
not synchronized even though
the time codes have been
synchronized. (Z on the Slave
device is not displayed.)
0
Is the [
TC IN/OUT] switch correctly set?
(A P68
[Synchronizing Time Code on Another Camera] )
0
Set [System] B [Record Set] B [Record Format] B [Frame & Bit
Rate] such that the two camera recorders have the same frame rate.
(A P
112 [ Frame & Bit Rate ] )
139
Others
To Next Page
Loading...
Need help?
General
