Operation Mode Description
Camera Mode
0
This
is the camera shooting mode. The camera recorder starts up in Camera mode
when the power is turned on.
0
Camera images are output on the viewfinder and LCD monitor. When a recordable
SD card is inserted, the camera recorder enters the recording standby mode.
“STBY” appears on the operation mode display area of the LCD monitor and
viewfinder.
0
Press the [REC] trigger button to start recording.
Memo :
0
Playback
of SD card is not possible in Camera mode. However, you can check the
most recently recorded video clip.
(A P72 [Viewing Recorded Videos Immediately (Clip Review)] )
Media Mode
0
This mode allows you to play back or delete clips recorded on the SD card.
0
When
a playable SD card is inserted, the thumbnail or playback screen is displayed
on the viewfinder and LCD monitor.
0
Press the [MODE] selection button to enter Media mode when you are not shooting
in Camera mode. Once the camera recorder is in Media mode, thumbnails of the
selected media slot are displayed.
USB Mode
0
This mode allows you to connect to a PC and transfer the files on an SD card to
the PC.
0
When
the camera recorder is connected to a USB cable, the message “Change to
USB Mode?” appears.
Select [Change] and press the Set button to switch to USB mode.
(A
P132 [Managing/Editing Clips on a PC] )
0
In USB mode, the camera recorder is recognized by the connected PC as a
peripheral drive. (USB mass storage class only)
Disable the connection on the PC and remove the USB cable from the camera
recorder to switch to Camera mode.
(A P132 [Managing/Editing Clips on a PC] )
Memo :
0
When a USB cable is connected during recording, the message appears after
recording stops.
0
If playback is in progress, the message appears once the files are closed
automatically, such as when playback stops.
0
Files on the PC cannot be written to the SD card.
17
Introduction
To Next Page
Loading...
Need help?
General
