Masterpage:Left-FullCol
48 EN
Filename [HM-100U_Eng_05Index.fm]
TIMER RECORDING (cont.)
END of TIMER RECORDING
ATTENTION:
If there is a conflict in the timer schedule and one
program overlaps with another, only the parts shown
below in gray will be recorded.
Pattern 1 : The program with the lower program
number will be recorded.
Pattern 2 : The program starting earlier will be
recorded.
Pattern 3 : The program starting earlier will be
recorded, followed by the remaining
portion of the other program.
10:00
11:00
CH10
12:00
CH40
Not
recorded
Program 1
Program 2
10:00
11:00
12:00
CH40
Not recorded
Program 1
Program 2
10:00
11:00
12:00
CH10
CH40
Not recorded
Program 1
Program 2
Other Useful functions for timer recording
You can also use the following functions for timer
recording.
•“AUTO TIMER” (A page 68)
When “AUTO TIMER” is set to “ON”, the timer
recording standby mode is automatically engaged
when the VCR is turned off. It is temporarily
canceled when the VCR is turned on. You do not
have to press [TIMER (j)] to engage or disengage the
timer recording standby mode.
•“AUTO SP N EP TIMER” (S-VHS/VHS only)
(A page 68)
If there is not enough tape to record the entire
broadcast for recording in SP mode, the VCR
automatically switches to EP mode to allow
complete recording. This feature is especially handy
when recording a broadcast of more than 2 hours in
length.
HM-DH100U_Eng.book Page 48 Thursday, August 5, 2004 1:54 PM
To Next Page
Loading...
Need help?
General
