Masterpage:Left-FullCol
78 EN
Filename [HM-100U_Eng_05Index.fm]
OTHER USEFUL FUNCTIONS (cont.)
i.LINK Set Up
i.LINK set up for connected device
When you connect i.LINK compatible devices to this
VCR, an i.LINK device number is assigned to each device
in the order of connection.
If you want to change the number, follow the procedure
below.
A Access Main Menu screen
Press [MENU].
B Access i.LINK Set Up screen
A Press [D E] to move the arrow to “INITIAL
SET UP”, then press [G] or [OK].
B Press [D E] to move the arrow to “OTHER”,
then press [G] or [OK].
C Confirm LINC setting
D Reset Number
E Return to normal screen
Press [MENU].
F Set Number again
Connect the external devices one by one.
• Make sure to connect the VCR’s AC power plug
to the AC outlet and turn on the external device
before connection.
• Each device will be numbered in the order of
connection.
NOTES:
• If you do not want to set i.LINK device number, set “LINC” to
“OFF” in step C.
• Use of i.LINK connection may not be possible depending on
the type of camcorders equipped with DV connector. In this
case, set “LINC” to “OFF” in step C.
• Even if a LINC is established between this VCR and an i.LINK-
compatible device, the digital tuner signal of this VCR will not
be output to the device from the [i.LINK] connector.
•Turn on the VCR and the TV, and select the AV
mode on the TV.
•Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
ATTENTION:
If the i.LINK setting does not work, press [D-VHS] and [STOP
(L)] on the front panel simultaneously for more than 5
seconds to reset the settings. The cassette is automatically
ejected.
LINC
You can control one of the i.LINK-compatible devices
connected to this VCR with the i.LINK cable. “LINC”
means to select one of the connected devices. After
establishing a LINC with an i.LINK-compatible device,
you’re ready to control the i.LINK device.
LINC (Logical Interface Connection) involves
establishing a logical connection, as the abbreviation
implies.
B - D
A
E
VCR
TV
CABLE
/DBS
Check that “LINC” is
set to “AUTO”. If not,
press [FG] to move
the arrow to “LINC”,
then press [D E] to
set to “AUTO”.
Press [FG] to move
the arrow to “RESET
NUMBER”, then press
[OK].
THEN PRESS [OK]
CLOCK SET
JLIP ID
LINC
RESET NUMBER
1
GUIDE CHANNEL OTHER
SELECT WITH ARROW KEYS
AUTO
SELECT
OK
EXIT
MENU
FUNCTION SET UP
TUNER SET UP INITIAL SET UP
DIGITAL SET UP
THEN PRESS [OK]
CLOCK SET
JLIP ID
LINC
RESET NUMBER
1
GUIDE CHANNEL OTHER
SELECT WITH ARROW KEYS
AUTO
SELECT
OK
EXIT
MENU
FUNCTION SET UP
TUNER SET UP INITIAL SET UP
DIGITAL SET UP
HM-DH100U_Eng.book Page 78 Thursday, August 5, 2004 1:54 PM
To Next Page
Loading...
Need help?
General
