Masterpage:Left-FullCol
42 EN
Filename [HM-100U_Eng_05Index.fm]
TIMER RECORDING (cont.)
Changing VCR
Plus+ C
3
®
Setting
To ensure that VCR Plus+ timer recording operates
correctly, it is necessary to set the VCR Plus+ “Guide
Channel Set” for each station. Read the following
information carefully.
VCR Plus+ guide channel matching
The VCR Plus+ programming system assigns a VCR Plus+
guide channel to the TV channels and the cable
channels. These guide channel numbers are also called
the VCR Plus+ channel codes. TV listings often have a
section in chart form, indicating the guide channel
number assigned to each station. For accurate VCR Plus+
programming, the VCR Plus+ guide channel number for
each station should match the channel number on which
it is received in your area.
NOTES:
• In many instances, the VCR Plus+ guide channel numbers for
cable and broadcast TV stations DO NOT match the channel
number on which it is received by your VCR or cable box.
Check your TV listing, or contact your cable supplier for
details.
• Many TV stations can be viewed on cable. Check your TV
listing, or contact your cable supplier for details.
•Turn on the VCR and the TV, and select the AV
mode on the TV.
•Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
A E
B - D
VCR
TV
CABLE
/DBS
IMPORTANT:
If you have moved to a different area or if a broadcasting
station’s channel number has been changed, the wrong VCR
CH or CABLE CH number will be displayed on the Program
screen (
A page 41 step E ). When this happens, perform
the following steps to set the correct guide channel number
for that station.
HM-DH100U_Eng.book Page 42 Thursday, August 5, 2004 1:54 PM
To Next Page
Loading...
Need help?
General
