JVC HR-DD949E - SHOW VIEW Setup

10 EN
IN ITIAL SETTIN GS (cont.)
SHOW VIEW
Setup
With SHOW VIEW , timer programming is greatly simplified
because each TV programme has a corresponding code number
which your recorder is able to recognise.
N OTE:
“Guide Program (GUIDE PROG) Number” refers to the assigned
TV station numbers, according to broadcast area, for S
HOW V IEW
timer recording.
IM PORTAN T
Perform the following procedure after Auto Set Up on page 4
and/or the channel setting steps on pages 44 – 47, and after the
Clock Set procedure on page 49.
After setting the Guide Program Numbers, the station names
and channel positions may be incorrect if you stored or skipped
channels. In this case, re-perform Guide Program Number
setting.
Turn on the TV and select the VIDEO channel (or AV mode).
MAKE LIST OF STORED
STATION NAMES AND
CHANNEL POSITIONS
1
(Ex.)
ACCESS MAIN MENU
SCREEN
2
Press M EN U twice.
ACCESS GUIDE PROG SET
SCREEN
3
Press PUSH JO G
%
fi to move the highlight bar
(pointer) to "GUIDE PROG SET", then press O K.
The Guide Prog. Set screen appears.
Channel position Station name
1 ARD
2 ZDF
3 WDR
Guide Progra m N umber Set
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
GUIDE PROG SET
CLOCK SET
JLIP ID NO. SET
[5
∞
] =
[MENU] : EXIT
5
GUIDE PROG SET
GUIDE PROG TV PROG
11
: AUTO SET BY SHOWVIEW
[ ]: MANUAL SET
[
5
∞] : ?
[MENU] : EXIT
* For Customers in Australia and New Zealand:
With this recorder, the G-Code system is identified as
"SHOW VIEW".
12
45
3
6
8
0
7
9
2
4
1
3
NU M BER
OK
CANCEL
PU SH JO G
M EN U
Downloaded from: https://www.usersmanualguide.com/