JVC KW-V830BT - Touch panel adjustment; Special Setup

Setting Up
66
Ñ Touch panel adjustment
1
Touch [Touch Panel Adjust] on the User
Interface screen.
 Touch Panel Adjust screen appears.
2
Follow the instruction on the screen and
long touch the center of each [ ].
1
2
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset to the initial status, touch [Reset].
Special Setup
You can setup Special parameters.
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 SETUP screen appears.
4
Touch [Special].
 Special screen appears.
5
Set each item as follows.
■ DEMO
Set the demonstration mode. Default is “ON”.
■ SETUP Memory
Locks or unlocks the Audio SETUP Memory/
Recall/Clear.
■ Audio SETUP Memory
Memorizes the current audio setting.
• Fader/ Balance, Speaker / X’over, Equalizer
(User Preset, SW Level), Position/DTA,
Sound Effect (P.69)
■ Audio SETUP Recall
Recalls the memorized audio setting.
■ Audio SETUP Clear
Clears the AUDIO SETUP Memory and the
currently memorized audio setting.
■ Software Information
Check the software version of this unit.
(P.66)
■ Open Source Licenses
Displays the open source licenses.
■ Initialize
Touch [Initialize] and then touch [Yes ] to set
all the settings to the initial default settings.
• Audio SETUP Memory is not initialized.
Ñ Software Information
Check the software version of this unit.
1
Touch [Software Information] in the
Special screen.
2
Confirm the software version.
NOTE
• For how to update the software, see the relevant
update procedure manual which comes with the
software.
!B5A-1733-00_17KWV-K_En.indb 66 2016/12/28 11:25