JVC RD-D227B - Adjusting the Sound Effect; Adjusting the Brightness; Setting of the Clock; Time Display

Adjusting the Sound Eect
Press the EQ button the remote control repeatedly to select Pop, Classic, Jazz or Rock for
your desired sound eect.
Adjusting the Brightness
Press the DIMMER button to select the brightness level.
Setting of the Clock
Manual Setting of the clock can only be done in STANDBY mode.
1. In STANDBY mode, press and hold the CLOCK button on the remote control until the
hour digits are ashing.
2. Press the
button on the remote control to adjust the hour digits while ashing, then
press the CLOCK button to conrm, then the minute digits will ash.
3. Press the
button to adjust the minute digits while ashing, then press the CLOCK
button on the remote control to conrm.
4. Press
/SCAN button to select 12-hour or 24-hour mode.
5. Each activated state will be cleared if any buttons are not pressed in about 15 seconds.
Time Display
When in ON mode, press the CLOCK button to show the current time on the display for a
few seconds.
Synchronising the Clock
When in STANDBY mode, press and hold /CLEAR button to synchronise the clock.
Press the
button on the remote control to select below options:
• RADIO: Only synchronize with the RDS radio station.
• OFF: Turn o clock synchronisation.
Press
button to conrm.
Setting the Alarm Timer
The clock must be correctly set for the timer to operate correctly.
1. In STANDBY mode, press and hold the SLEEP/TIMER button on the remote control
until the hour digits ash on the display.
2. Press the
button on the remote control to adjust the hour digits, and then press the
SLEEP/TIMER button to conrm. The minute digits will ash on the display.
3. Press the
button on the remote control to adjust the minute digits, and then press
the SLEEP/TIMER button to conrm, the tuner timer will ash on the display
4. Press the
button on the remote control to select BUZZER, DISC, FM, DAB, or USB
mode, and then press the SLEEP/TIMER button to conrm, the display will show the
volume level.
5. Press the
button on the remote control to adjust the volume, and then press the
SLEEP/TIMER button on the remote control to conrm, “ ” will show on the display.
16
RD-D227B_IB_Final190415V6.indd 16 16/04/2019 16:24