JVC RX-D301S Service Manual

1-10 (No.MB479)
3.1.4 Removing the tuner
(See Fig.6)
• Remove the top cover.
(1) Disconnect the card wire from the connector CN1 on the
tuner.
(2) From the back side of the main body, remove the two
screws G attaching the tuner to the rear panel and take out
the tuner.
3.1.5 Removing the subwoofer board
(See Fig.6)
• Remove the top cover.
(1) Disconnect the wire from the connector CN524
on the sub-
woofer board.
(2) From the back side of the main body, remove the screw H
attaching the subwoofer board to the rear panel and take
out the subwoofer board.
3.1.6 Removing the front video board
(See Fig.6)
• Remove the top cover.
Reference:
Remove the tie band bundling the wires.
(1) Disconnect the wire from the connector CN662
on the vol-
ume board
(2) From the back side of the main body, remove the two
screws J.
(3) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
(4) Take out the front video board from the main body.
3.1.7 Removing the compulink board
(See Fig.6) [For Australia]
• Remove the top cover.
(1) Disconnect the wire from the connector CN565
on the com-
pulink board.
(2) From the back side of the main body, remove the screw K
and take out the compulink board from the main body.
Fig.6
Tuner
Volume board
CN524
GJ H
Rear panel
Subwoofer board
Front video board
CN1
CN662
Coaxial connector
Nut and washer
GJ H
Rear panel
Coaxial connector
Nut and washer
[For Australia]
[For Europe]
K
Tuner
Volume board
CN524
Rear panel
Subwoofer board
Front video board
CN1
CN565
CN662
Compulink board

JVC RX-D301S Specifications

General

Brand	JVC
Model	RX-D301S
Category	Receiver
Language	English